training:sanog32:0-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
training:sanog32:0-setup [2018/07/23 15:45] – [Summary of the commands entered] philip | training:sanog32:0-setup [2018/07/24 11:04] (current) – [Links to other Routers] philip | ||
---|---|---|---|
Line 17: | Line 17: | ||
The lab will start simply by configuring each autonomous system, and making sure that transit works via their transit provider. The address plan for the entire network is described in the [Address Plan](address-plan) document. The initial set up is shown below. | The lab will start simply by configuring each autonomous system, and making sure that transit works via their transit provider. The address plan for the entire network is described in the [Address Plan](address-plan) document. The initial set up is shown below. | ||
- | {{: | + | {{: |
===== Preliminary ===== | ===== Preliminary ===== | ||
Line 40: | Line 40: | ||
- | The following configuration examples show the suggested/ | + | The following configuration examples show the suggested/ |
- | + | ||
- | Note that we will not configure the Customer (CustX) router yet - this will be done later on in the lab exercises. | + | |
==== Name the router ==== | ==== Name the router ==== | ||
Line 163: | Line 161: | ||
Now we will configure the router physical interfaces according to the diagram. | Now we will configure the router physical interfaces according to the diagram. | ||
- | The configuration example below shows what to do for the link between CX and BX. You will need to set up similar configuration for the links between CX and AX and between CX and PX. | + | The configuration example below shows what to do for the link between CX and BX. You will need to set up similar configuration for the links between CX and AX, and between CX and PX. |
**On CX:** | **On CX:** |
training/sanog32/0-setup.1532324754.txt.gz · Last modified: 2018/07/23 15:45 by philip